Pull-outs
- Choice of front species and thickness
- Any size lip on top, bottom or sides of front
- Any standard or custom scoop hand pull design
- Any standard or custom tapered side profile
Available with the following options:
Top view
P1) Basic Pull-out
Standard drawer box using a premium front with an 1/8" radius of the face (no lip.)
Top view
P2) Premium pull-out
Same as P1 with 3/4" front
Top view
P3) Lip Front pull-out
Same as P2 with 3/4" front and 3/8" thick lip that extends 3/8" on either side of the face to conceal the slides.
Note: Drawer width does not include the lip. Drawer length is measured from the face to the back.
The lip should be added to the length of the slide to determine the length of the drawer, (i.e. 22 3/8" for a 22" slide.)
Top view
P4) Under-Mount pull-out with lip front
For 1/2" this side only, same as P2 but with 1/8" lip on either side.
Side view
P5) Deluxe Under-Mount pull-out
Same as P2 but with 3/8" lip at the bottom of the face to conceal the slides from the front
P6) Deluxe Under-Mount pull-out with lip
Combination of the P4 (1/2" thick) and P5 with 1/8" lip at each side and 3/8" lip at the bottom of the face to conceal the slides from the front.
Note 1: When using Under-Mount hardware on pull-outs, the difference in the thickness of the front and the side should be added to the length (depth).
Note 2: Specific 3/32" radius edge, sharp edges, or square eased edges of the face of the pull-out. You can also request the outside face to be unfinished so you can finish the fronts to match the rest of your job.